soft-robotics:general-recipe
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
soft-robotics:general-recipe [2017/04/25 04:27] avnerus [9 Place the molds in the oven at 65C] |
soft-robotics:general-recipe [2017/04/25 04:28] avnerus [11 Make new silicone for the base layer + gluing] |
||
|---|---|---|---|
| Line 52: | Line 52: | ||
| Notice that if you overfilled your mold, you may have silicone attached above the edges of the mold. Use a utility knife to cut the excess attachment. | Notice that if you overfilled your mold, you may have silicone attached above the edges of the mold. Use a utility knife to cut the excess attachment. | ||
| + | |||
| + | {{:soft-robotics:10.png?nolink&400|}} | ||
| ===== - Make new silicone for the base layer + gluing ===== | ===== - Make new silicone for the base layer + gluing ===== | ||
| Do not reuse old silicone as it may have already been cured. | Do not reuse old silicone as it may have already been cured. | ||
| + | {{:soft-robotics:04.png?nolink&400|}} | ||
| ===== - Glue the body layer to the base layer ==== | ===== - Glue the body layer to the base layer ==== | ||
| - First put the base silicone back into its mold. | - First put the base silicone back into its mold. | ||
soft-robotics/general-recipe.txt ยท Last modified: 2017/04/25 04:30 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
