soft-robotics:molds:fast-bending
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
soft-robotics:molds:fast-bending [2017/04/23 08:58] avnerus |
soft-robotics:molds:fast-bending [2017/04/23 09:31] avnerus |
||
|---|---|---|---|
| Line 21: | Line 21: | ||
| * Base Layer: ~5g | * Base Layer: ~5g | ||
| - | ==== Oven times ==== | + | ===== Oven times ===== |
| === Basic shape === | === Basic shape === | ||
| Line 27: | Line 27: | ||
| * [[soft-robotics:silicones:ecoflex30|Ecoflex 30]]: ~15min | * [[soft-robotics:silicones:ecoflex30|Ecoflex 30]]: ~15min | ||
| + | ===== Air inlet ===== | ||
| + | From the toolkit website: | ||
| + | <code> | ||
| + | Using a thin metal rod, pierce the end of the actuator, an equal distance from both sides | ||
| + | and about 1/8” (3mm) from the bottom. Aim the rod slightly downwards and don’t push it in too far. | ||
| + | The goal is to reach the central channel without puncturing any of the actuator’s walls. | ||
| + | </code> | ||
| + | |||
| + | {{:soft-robotics:molds:14.png?nolink&400 |}} | ||
| + | {{:soft-robotics:molds:fba_inlet.png?nolink&400 |}} | ||
soft-robotics/molds/fast-bending.txt · Last modified: 2017/04/26 16:00 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
