This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
soft-robotics:molds:fast-bending [2017/04/23 09:31] avnerus |
soft-robotics:molds:fast-bending [2017/04/26 16:00] avnerus |
||
---|---|---|---|
Line 2: | Line 2: | ||
The Fast Bending Actuator is the most basic Pneunet design that is based on the [[soft-robotics:fast-pneunet|Fast Pneunet]] architecture. Its design is based on the research paper by Dr. Bobak Mosadegh: [[http://onlinelibrary.wiley.com/doi/10.1002/adfm.201303288/full|Pneumatic Networks for Soft Robotics that Actuate Rapidly]]. | The Fast Bending Actuator is the most basic Pneunet design that is based on the [[soft-robotics:fast-pneunet|Fast Pneunet]] architecture. Its design is based on the research paper by Dr. Bobak Mosadegh: [[http://onlinelibrary.wiley.com/doi/10.1002/adfm.201303288/full|Pneumatic Networks for Soft Robotics that Actuate Rapidly]]. | ||
+ | |||
+ | {{:soft-robotics:molds:fast_bending.png?nolink&600|}} | ||
===== Fabrication ===== | ===== Fabrication ===== | ||
Line 14: | Line 16: | ||
* Two | * Two | ||
* Three | * Three | ||
+ | |||
+ | ===== Machine Limitations ===== | ||
+ | The bottom half of the top layer cannot be laser cut. | ||
===== Quantities ===== | ===== Quantities ===== |