soft-robotics:connectors
Differences
This shows you the differences between two versions of the page.
|
soft-robotics:connectors [2017/04/10 10:14] avnerus created |
soft-robotics:connectors [2018/05/12 10:11] (current) avnerus |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ===== Info ===== | ===== Info ===== | ||
| Connector are used to connect between tubes of different sizes. | Connector are used to connect between tubes of different sizes. | ||
| + | |||
| {{:soft-robotics:f0317768-01.jpg?nolink&400 |}} | {{:soft-robotics:f0317768-01.jpg?nolink&400 |}} | ||
| Line 11: | Line 12: | ||
| ===== Uses ===== | ===== Uses ===== | ||
| - | For our uses, most of the work is done using 3mm splitters that join between valves and actuators on 2mm tubings. | + | For our uses, most of the work is done using 4mm splitters that connect to 3mm (Inner)- 5mm (Outer) tubings. |
| - | We can use 4mm->3mm reducers to connect the [[soft-robotics:pumps:mitsumi-r14-a221|pump]] to the rest of the pneunet. | + | ===== Types ===== |
| + | * T-Piece Splitter | ||
| + | * Straight Reducing | ||
soft-robotics/connectors.1491819247.txt.gz · Last modified: 2017/04/10 10:14 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
