soft-robotics:molds:slow-bending
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
soft-robotics:molds:slow-bending [2017/05/08 09:50] avnerus |
soft-robotics:molds:slow-bending [2017/05/08 10:04] (current) avnerus |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| The Slow Bending Actuator is a basic Pneunet design that is based on the [[soft-robotics:slow-pneunet|Slow Pneunet]] architecture. It is based on a research by Harvard University and the molds on this wiki are designed by [[https://pure.itu.dk/portal/en/persons/jonas-joergensen(8758dd24-d86a-4dab-be44-fa4e9e903141).html|Jonas Jørgensen]] - Researcher at the IT University of Copenhagen. | The Slow Bending Actuator is a basic Pneunet design that is based on the [[soft-robotics:slow-pneunet|Slow Pneunet]] architecture. It is based on a research by Harvard University and the molds on this wiki are designed by [[https://pure.itu.dk/portal/en/persons/jonas-joergensen(8758dd24-d86a-4dab-be44-fa4e9e903141).html|Jonas Jørgensen]] - Researcher at the IT University of Copenhagen. | ||
| + | {{:soft-robotics:molds:slow_bending.png?nolink&100|}} | ||
| ===== Fabrication ===== | ===== Fabrication ===== | ||
soft-robotics/molds/slow-bending.1494237026.txt.gz · Last modified: 2017/05/08 09:50 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
