soft-robotics:tubings:silicone
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
soft-robotics:tubings:silicone [2018/05/12 10:24] avnerus |
soft-robotics:tubings:silicone [2018/05/12 10:24] (current) avnerus |
||
|---|---|---|---|
| Line 8: | Line 8: | ||
| ===== Sizes ===== | ===== Sizes ===== | ||
| We have used two different tube sizes: | We have used two different tube sizes: | ||
| - | - **5mm Outer Diameter => 3mm Inner Diameter** - These were the most wildly used tubes. They would connect to the actuators, to valves and pumps. | + | - **5mm Outer Diameter => 3mm Inner Diameter** - These were the most wildly used tubes. They would connect to the actuators, valves and pumps. |
| - **4mm Outer Diameter => 2mm Inner Diameter** - Those are used when a thinner tubing is necessary, for example in small actuators. | - **4mm Outer Diameter => 2mm Inner Diameter** - Those are used when a thinner tubing is necessary, for example in small actuators. | ||
| - **6mm Outer Diameter => 4mm Inner Diameter** - Those can be used when a larger throughput of air is required. | - **6mm Outer Diameter => 4mm Inner Diameter** - Those can be used when a larger throughput of air is required. | ||
soft-robotics/tubings/silicone.1526120678.txt.gz · Last modified: 2018/05/12 10:24 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
