soft-robotics:electrical-components:chamber-pcb
This is an old revision of the document!
Table of Contents
Pneumatic Chamber PCB
Design
- KiCAD Project: https://github.com/autotel/Hitodama-valves-board
Configuration for v1
- Used Roland Monofab SRM20.
- Tool preset:
Notes
- Next time we should use 0.31 instead of 0.3, to add tolerance space.
- There were some traces of ground connections that are not used that overloaded the path calculation.
soft-robotics/electrical-components/chamber-pcb.1555508140.txt.gz · Last modified: 2019/04/17 13:35 by avnerus
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
