Differences

This shows you the differences between two versions of the page.

--- soft-robotics:electrical-components:chamber-pcb [2019/04/17 13:35]
avnerus created
+++ soft-robotics:electrical-components:chamber-pcb [2019/06/02 07:48] (current)
avnerus
@@ Line 1: / Line 1: @@
-====== Pneumatic Chamber PCB ======
+====== Soft Robotics PCB ======
-===== Design =====
+===== Pneumatic Chamber board =====
+==== Design ====
   * KiCAD Project: https://github.com/autotel/Hitodama-valves-board
-===== Configuration for v1 =====
+==== Configuration for v1 ====
   * Used Roland Monofab SRM20.
@@ Line 12: / Line 15: @@
  {{:soft-robotics:electrical-components:roland_monofab_srm20-preset.png?nolink&600|Tool preset}}
-===== Notes =====
+==== Notes ====
   * Next time we should use 0.31 instead of 0.3, to add tolerance space.
@@ Line 18: / Line 21: @@
 {{:soft-robotics:electrical-components:hitodama-pcb.jpg?nolink&600|}}
+==== Breakout board ====
+Link to required copper clad (for SRM-20): https://www.digikey.fi/product-detail/en/mg-chemicals/589/473-1011-ND/559724
+===== Teensy Board =====
+==== Notes ====
+  * The VCC link bypasses the Teensy? It should connect to the 3.3V pin between pin 12 and 24 of the teensy and also to the standard 3.3V pin at the top.
+  * Cannot use the DAC pins (A21,A22) as digital!
+  * Teensy was a bit too much close to the edge? Maybe can center it a bit more?