soft-robotics:electrical-components:chamber-pcb
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
soft-robotics:electrical-components:chamber-pcb [2019/06/01 19:17] avnerus |
soft-robotics:electrical-components:chamber-pcb [2019/06/02 07:48] (current) avnerus |
||
|---|---|---|---|
| Line 31: | Line 31: | ||
| ==== Notes ==== | ==== Notes ==== | ||
| - | * The VCC link bypasses the Teensy? It should connect to the 3.3V pin between pin 12 and 24 of the teensy | + | * The VCC link bypasses the Teensy? It should connect to the 3.3V pin between pin 12 and 24 of the teensy and also to the standard 3.3V pin at the top. |
| * Cannot use the DAC pins (A21,A22) as digital! | * Cannot use the DAC pins (A21,A22) as digital! | ||
| + | * Teensy was a bit too much close to the edge? Maybe can center it a bit more? | ||
soft-robotics/electrical-components/chamber-pcb.1559416648.txt.gz ยท Last modified: 2019/06/01 19:17 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
