soft-robotics:fast-pneunet
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
soft-robotics:fast-pneunet [2017/04/16 09:10] avnerus |
soft-robotics:fast-pneunet [2017/04/16 09:20] avnerus |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| The design of fast pneummatic networks was first outlined in the Harvard University paper: {{ :soft-robotics:mosadegh_et_al-2014-advanced_functional_materials.pdf |Pneumatic Networks for Soft Robotics that Actuate Rapidly}}. Its fabrication process is described in the [[http://http://softroboticstoolkit.com/|Soft Robotics Toolkit]] website. | The design of fast pneummatic networks was first outlined in the Harvard University paper: {{ :soft-robotics:mosadegh_et_al-2014-advanced_functional_materials.pdf |Pneumatic Networks for Soft Robotics that Actuate Rapidly}}. Its fabrication process is described in the [[http://http://softroboticstoolkit.com/|Soft Robotics Toolkit]] website. | ||
| + | As opposed to [[soft-robotics:slow-pneunet|Slow Pneunets]] that are composed of uniformly interconnected pressurized cells, the fast pneunet inserts a gap between cells in order to minimize the volume that is pressurized. This results in a more efficient design that requires less pressure in order to actuate. | ||
| + | |||
| + | {{:soft-robotics:fpn-spn1.png?nolink&400|}}{{ :soft-robotics:fpn-spn2.png?nolink&400|}} | ||
soft-robotics/fast-pneunet.txt ยท Last modified: 2017/04/16 15:10 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
