This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
soft-robotics:general-recipe [2017/04/25 04:28] avnerus [12 Glue the body layer to the base layer] |
soft-robotics:general-recipe [2017/04/25 04:29] avnerus [13 Pierce a hole in the actuator and insert the tube] |
||
---|---|---|---|
Line 74: | Line 74: | ||
Refer to the page of your [[soft-robotics:molds|mold]] for specific instructions on where and how to pierce the hole. | Refer to the page of your [[soft-robotics:molds|mold]] for specific instructions on where and how to pierce the hole. | ||
+ | {{:soft-robotics:molds:14.png?nolink&400|}} | ||
===== - Gently test inflation with a syringe ==== | ===== - Gently test inflation with a syringe ==== | ||
**Do not inflate too much!** - If the inflation works properly, let the actuator rest and cure until the next day. Two main issues may be revealed: | **Do not inflate too much!** - If the inflation works properly, let the actuator rest and cure until the next day. Two main issues may be revealed: |