Differences

This shows you the differences between two versions of the page.

--- soft-robotics:molds:fast-bending [2017/04/23 09:25]
avnerus
+++ soft-robotics:molds:fast-bending [2017/04/24 08:51]
avnerus
@@ Line 2: / Line 2: @@
 The Fast Bending Actuator is the most basic Pneunet design that is based on the [[soft-robotics:fast-pneunet|Fast Pneunet]] architecture. Its design is based on the research paper by Dr. Bobak Mosadegh: [[http://onlinelibrary.wiley.com/doi/10.1002/adfm.201303288/full|Pneumatic Networks for Soft Robotics that Actuate Rapidly]].
+{{:soft-robotics:molds:fast_bending.png?nolink&600|}}
 ===== Fabrication =====
@@ Line 26: / Line 28: @@
   * [[soft-robotics:silicones:dragonskin30|Dragon Skin 30]]: ~35min
   * [[soft-robotics:silicones:ecoflex30|Ecoflex 30]]: ~15min
+===== Air inlet =====
+From the toolkit website:
+<code>
+Using a thin metal rod, pierce the end of the actuator, an equal distance from both sides
+and about 1/8” (3mm) from the bottom.  Aim the rod slightly downwards and don’t push it in too far.
+The goal is to reach the central channel without puncturing any of the actuator’s walls.
+</code>
+{{:soft-robotics:molds:14.png?nolink&400 |}}
+{{:soft-robotics:molds:fba_inlet.png?nolink&400 |}}