soft-robotics:sensors:mps-20n004d0d
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
soft-robotics:sensors:mps-20n004d0d [2019/02/16 17:39] avnerus |
soft-robotics:sensors:mps-20n004d0d [2019/02/19 08:56] avnerus |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| The circuits I have seen online use two connections to the LM358, first as a differential amplifier and then as a normal amplifier. | The circuits I have seen online use two connections to the LM358, first as a differential amplifier and then as a normal amplifier. | ||
| I believe that I can manage with just differential amplification, because it provides both amplification to the signal and eliminating the 2.5v offset of the output. | I believe that I can manage with just differential amplification, because it provides both amplification to the signal and eliminating the 2.5v offset of the output. | ||
| + | |||
| + | **The following setup is for 3.3v on the Teensy** | ||
| {{:soft-robotics:sensors:pressure_sensor_connection_avner.png?800|}} | {{:soft-robotics:sensors:pressure_sensor_connection_avner.png?800|}} | ||
soft-robotics/sensors/mps-20n004d0d.txt ยท Last modified: 2021/12/15 16:11 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
