This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
soft-robotics:slow-pneunet [2017/04/16 09:30] avnerus created |
soft-robotics:slow-pneunet [2017/04/25 04:11] (current) avnerus [Slow Pneunet] |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Slow Pneunet ====== | ====== Slow Pneunet ====== | ||
- | The Slow Pneumatic network is an older and less efficient design than the [[soft-robotics:fast|Fast Pneunet]]. Visually however, it produces actuators that have a more uniform and less segmented body that inflates more smoothly across the entire surface. | + | The Slow Pneumatic network is an older and less efficient design than the [[soft-robotics:fast-pneunet|Fast Pneunet]]. Visually however, it produces actuators that have a more uniform and less segmented body that inflates more smoothly across the entire surface. |
+ | |||
+ | ===== Molds ===== | ||
+ | These molds are designed as Slow Pneumatic Networks: | ||
+ | * [[soft-robotics:molds:slow-bending|Slow Bending Actuator]] | ||
+ | * [[soft-robotics:molds:gripper|Gripper]] | ||
+ | * [[soft-robotics:molds:triangle|Triangle]] | ||
+ | * [[soft-robotics:molds:leaf|Leaf]] | ||
+ | |||
+ | ===== Silicone Layers ===== | ||
+ | We have successfully experimented with the following layer combinations. | ||
+ | ^ Top layer (extensible) ^ Bottom Layer (inextensible) ^ | ||
+ | | [[soft-robotics:silicones:ecoflex30|Ecoflex 30]] | [[soft-robotics:silicones:dragonskin30|Dragon Skin 30]] | | ||
+ | | [[soft-robotics:silicones:ecoflex30|Ecoflex 30]] | [[soft-robotics:silicones:dragonskin30|Dragon Skin 30]] + Office Paper | |