soft-robotics:slow-pneunet
This is an old revision of the document!
Table of Contents
Slow Pneunet
The Slow Pneumatic network is an older and less efficient design than the Fast Pneunet. Visually however, it produces actuators that have a more uniform and less segmented body that inflates more smoothly across the entire surface.
Molds
These molds are designed as Slow Pneumatic Networks:
Silicone Layers
We have successfully experimented with the following layer combinations.
| Top layer (extensible) | Bottom Layer (inextensible) |
|---|---|
| Ecoflex 30 | Dragon Skin 30 |
| Ecoflex 30 | Dragon Skin 30 + Office Paper |
soft-robotics/slow-pneunet.1492355688.txt.gz · Last modified: 2017/04/16 15:14 by avnerus
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
