soft-robotics:molds:fast-bending
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
soft-robotics:molds:fast-bending [2017/04/23 09:31] avnerus |
soft-robotics:molds:fast-bending [2017/04/26 16:00] (current) avnerus |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| The Fast Bending Actuator is the most basic Pneunet design that is based on the [[soft-robotics:fast-pneunet|Fast Pneunet]] architecture. Its design is based on the research paper by Dr. Bobak Mosadegh: [[http://onlinelibrary.wiley.com/doi/10.1002/adfm.201303288/full|Pneumatic Networks for Soft Robotics that Actuate Rapidly]]. | The Fast Bending Actuator is the most basic Pneunet design that is based on the [[soft-robotics:fast-pneunet|Fast Pneunet]] architecture. Its design is based on the research paper by Dr. Bobak Mosadegh: [[http://onlinelibrary.wiley.com/doi/10.1002/adfm.201303288/full|Pneumatic Networks for Soft Robotics that Actuate Rapidly]]. | ||
| + | |||
| + | {{:soft-robotics:molds:fast_bending.png?nolink&600|}} | ||
| ===== Fabrication ===== | ===== Fabrication ===== | ||
| Line 14: | Line 16: | ||
| * Two | * Two | ||
| * Three | * Three | ||
| + | |||
| + | ===== Machine Limitations ===== | ||
| + | The bottom half of the top layer cannot be laser cut. | ||
| ===== Quantities ===== | ===== Quantities ===== | ||
soft-robotics/molds/fast-bending.1492939874.txt.gz ยท Last modified: 2017/04/23 09:31 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
