soft-robotics:molds:fast-bending
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
soft-robotics:molds:fast-bending [2017/04/24 08:51] avnerus |
soft-robotics:molds:fast-bending [2017/04/26 16:00] (current) avnerus |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| * Two | * Two | ||
| * Three | * Three | ||
| + | |||
| + | ===== Machine Limitations ===== | ||
| + | The bottom half of the top layer cannot be laser cut. | ||
| ===== Quantities ===== | ===== Quantities ===== | ||
soft-robotics/molds/fast-bending.1493023889.txt.gz ยท Last modified: 2017/04/24 08:51 by avnerus
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
