soft-robotics:molds:fast-pneunet
This is an old revision of the document!
Table of Contents
Pneumatic surface CNC
Based on the Fast Pneunet architecture.
Fabrication
Cavity: Polyurethane foam, acrylic glass and screws. CNC milled and assembled <br/>Bottom layer: acrylic glass, double sided tape
Mold files
Quantities
Oven times
Ecoflex 30 about 20 min at 65°C
Basic shape
Air inlet
The Bottom plate has holes in order to place the tubing before casting the bottom surface.
soft-robotics/molds/fast-pneunet.1515695978.txt.gz · Last modified: 2018/01/11 18:39 by kilian
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
