soft-robotics:molds:fast-bending
This is an old revision of the document!
Table of Contents
Fast Bending Actuator
The Fast Bending Actuator is the most basic Pneunet design that is based on the Fast Pneunet architecture. Its design is based on the research paper by Dr. Bobak Mosadegh: Pneumatic Networks for Soft Robotics that Actuate Rapidly.
Fabrication
The fabrication process is described in detail on the Soft Robotics Toolkit page.
Mold files
The Downloads section on the toolkit website contains all of the molds.
Our variations
We have made several variations on the molds:
- One
- Two
- Three
soft-robotics/molds/fast-bending.1492936864.txt.gz · Last modified: 2017/04/23 08:41 by avnerus
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
