soft-robotics:slow-pneunet
Table of Contents
Slow Pneunet
The Slow Pneumatic network is an older and less efficient design than the Fast Pneunet. Visually however, it produces actuators that have a more uniform and less segmented body that inflates more smoothly across the entire surface.
Molds
These molds are designed as Slow Pneumatic Networks:
Silicone Layers
We have successfully experimented with the following layer combinations.
| Top layer (extensible) | Bottom Layer (inextensible) |
|---|---|
| Ecoflex 30 | Dragon Skin 30 |
| Ecoflex 30 | Dragon Skin 30 + Office Paper |
soft-robotics/slow-pneunet.txt · Last modified: 2017/04/25 04:11 by avnerus
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
